During Operation¶
DANGER
Confirm all cables are properly insulated prior to machine operation. [Electric shock]
Do not operate with wet hands. [Electric shock]
Confirm no personnel or obstacles remain inside protective covers or close to rotating or moving parts before starting machine operation. [Entanglement/Collision]
WARNING
Do not change machine specifications, parameters or modify the machine without prior consultation with DynamiTech. [Impaired machine performance/Machine service life reduction]
Before using a switch, button, or key, perform visual confirmation and then press or set decisively to avoid selection errors. [Mechanical error]
When operating noise may be produced, change cutting conditions to limit the generation of noise or ensure the operator wears protective gear to avoid injury due to excessive noise levels. [Impaired hearing]
This is not the explosion-proof specification machine. Dangers such as the ejection of a large workpiece or harmful dust or an explosion caused by the machining of metals such as magnesium are not preventable even if the door is closed. Do not rely on door and protective devices alone. Recognition of the dangers involved in machining procedures is required at all times.
Before operating the machine, confirm there are no personnel or obstacles around or inside the machine. Keep distance from moving parts. [Injury/Machine damage, interference]
When the machine is operated by more than one operator, cooperation and communication between them is required at all times. [Accident]
Keep distance from spindle or other rotating parts. [Entanglement]
Wear safety glasses at all times (including operators wearing prescription glasses). [Eye damage due to ejected foreign matter]
Do not wear gloves when operating the machine. [Entanglement/Machine malfunction]
Use a crane or lifter to mount or remove heavy workpieces. [Injury]
Bolts used for fixtures should be periodically replaced with the bolts specified by DynamiTech that have appropriate strength. [Bolt breakage/Workpiece, fixture, cutting tool ejection/Serious injuries/Machine damage]
Ensure workpiece, cutting tool, holder, soft jaws, and tailstock (if installed) are tightened securely. [Workpiece, cutting tool ejection]
Machining conditions such as depth of cut or feedrates must be set in stages with sufficient leeway during test cutting. [Workpiece, cutting tool ejection]
Do not place hands or feet inside the chip conveyor (if installed) during operations. [Entanglement]
STOP the machine and coolant supply before removing chips or adjusting the direction or volume of the coolant supply. [Entanglement]
Remove the workpiece from the machine before deburring it by hand. [Entanglement/Injury]
Always work at a safety margin of at least 20 cm from the window. This impact resistant window could be substantially deformed to ease the impact of an ejected tool, or could break if struck very hard. [Injury]
When using the stopper inside the spindle, confirm the adjusting shaft does not protrude excessively from the rear of the spindle. [Shaft ejection during spindle rotation]
When operating a machine equipped with a hollow chuck, install the attached through hole cover to the chuck if the through hole is not used. [Chuck, cylinder or other hydraulic circuit malfunction due to entry of coolant or chips]
Contact the DynamiTech Service Department before grinding. [Grinding stone and cover breakage]
Optional specifications machines must be operated in compliance with such specifications.