Chuck Mounting

WARNING

When mounting a chuck, chuck cylinder, or connecting rod in the spindle, read the instruction manuals of DynamiTech, the chuck manufacturer, and the chuck cylinder manufacturer prior to performing the procedure. [Chuck, chuck cylinder or connecting rod damage]

The chuck or fixture clamping the workpiece must be secured to the spindle using the threaded holes in the spindle nose. [Chuck and fixture ejection]

If a workpiece holding chuck or fixture other than the chuck supplied with the machine is used, contact the DynamiTech Service Department prior to machine operation to prevent serious injury and machine damage.

If the chuck supplied with the machine is removed from the machine and a specially prepared fixture is used, remove the chuck cylinder and connecting rod. [Connecting rod, chuck cylinder ejection]

Leave the pilot bush mounted in the chuck when operating the machine. [Master jaw or chuck jaw ejection]

Use only specified bolts to mount the chuck and tighten to the specified torque. Check at regular intervals to ensure the bolts are securely tightened. [Workpiece ejection/Chuck damage]

Note

DynamiTech is not responsible for accidents caused by the use of a chuck or fixture prepared by the customer without prior consultation.